To avoid electrical shocks and injuries during installation it is essential to disconnect the ground cable (negative pole) from the battery of the vehicle.
1) Select a suitable location. The surface must be free of dirt and grease. Remove the protective foil of the adhesive pads and apply the SMD FlexStripes by pressing firmly.
Do not attach the adhesive pads to leather, fabric or wood.
2) Run the power cable (black (-), black/white (+)). Important: keep the cable away from heat sources (heater etc.). Note the remaining length of the cable so that the cable is run free of tension.
3) Connection (power supply) over fuse box (terminal 15/30) or vehicle battery. We recommend interconnecting a suitable On/Off switch.
Safety precautions
Improper installation, manipulation of components, etc. can constitute a danger and will void any and all warranty claims. Mount at a protected
location so that damages through external influence such as foot contact when entering the vehicle are avoided. Check the SMD FlexStripes
to assure a secure fit as well as the electrical connections on a regular basis. Take special care that none of the cables are pinched or buckled
and are protected from chafing or breakage. To avoid an interruption of the contacts (failure of function), the SMD-FlexStripes must not be
buckled.
For installation in Countries outside the Federal Republic of Germany, the national homologation regulations apply.
