1) Thoroughly clean surface to remove all grease, dust and polish residues (e.g. with a silicon remover) and dry with a cotton cloth.
2) Match decorative stripes to the part of the vehicle to be covered and trim to size with scissors.
3) Only peel off the protective paper on the adhesive side of the film by a half at the maximum.
4) Apply film stripes while holding them slightly taut. Press down by carefully running over with your finger. Continue to peel back the protective paper and press on the strip step by step.
Note: allow to dry for approx. 1 hr following fitting. Do not wash vehicle in the car wash system for 3 days. The film must not be fitted on ‘fresh’ paintwork as paint takes approx. 2 months to cure. We recommend leaving the film on the paintwork for a maximum of two years. It should then be replaced!
