|
|
|
|
 |
 |
 |
| |
|
|
|
Please read the instruction manual carefully before usage.
Contents: 2 NEON-FlexTube with cigarette lighter connection, control unit
Clean the surface where the cables are to be attached with silicon remover (for fastening the self adesive pads).
Please note:
NEON-FlexTube are for installation only in dry vehicle interiors where they are protected from water and are not visible from outside. Do not position them within the driver’s direct field of vision (only below the top edge of the instrument lighting panel). The transformer may become hot during longer periods in use. Make absolutely sure there is sufficient ventilation! The guarantee does not cover installation mistakes, incorrect polarity, improper installation, or incorrect use of the components, etc.
Safety instructions:
It is illegal to install this product on the exterior of the vehicle or in a place from which it can be seen from outside. Installation of this nature is not permitted under [German] Road Traffic Laws. Please observe the country-specific legal requirements. Do not install near the car radio or heating systems. The functions of other electronic equipment (e.g. ABS system, navigation equipment, etc.) may possibly be adversely affected.
NEON-FlexTube is only for use on 12 V DC. In order to prevent cable fires, short circuits, etc. use the correct intermediate fuse, and let the installation be checked by an authorised auto electrician. Install in a protected place to avoid damage to the NEON-FlexTube by passengers getting in and out of the vehicle. Periodically check to be sure that the electrical connections are sound and the adhesive is firmly attached. Please make absolutely sure that cables cannot be crushed or bent and that they are protected from any risk of breakage or abrasion.
Input voltage: 12 V DC
|
|
|
|
 |
 |
 |
|
|
|
