Please read the instruction manual carefully before usage.
Caution
Do not install the product on the exterior of the vehicle or where it can impede the vision of the driver. This application is not permitted under the Motor Vehicle Safety Standards. Consult your local motor vehicle registration ordinances. Do not install in the immediate vicinity of the car radio or the heating ducts. Other electronic devices, such as the ABS system, navigation devices etc. may be impeded in their function.
Rated Voltage 12 V DC
Rated Current: 50mA
Do not touch tubes when it is in use. In order to prevent cable fires, short circuits, etc. let the installation be checked by an authorised auto electrician. Neither the manufacturers nor the distributors can accept any responsibility for any damage caused by incorrect installation. For installation in Countries outside the Federal Republic of Germany, the national homologation regulations apply.
Caution: To avoid electrical shocks and injuries during installation it is essential to disconnect the ground cable (negative pole) from the battery of the vehicle.
1) Select a suitable location. The surface must be free of dirt and grease.
Remove the protective foil of the adhesive pads and apply the LED SkyLine by pressing firmly. Please note: Do not attach the adhesive pads to leather, fabric or wood. 2) Place the power supply cable. Important: keep the cable away from heat sources (heater etc.). Note the remaining length of the cable so that the cable is run free of tension. (The cables should be placed so that they cannot fray or break!) 3) Power supply: connect to fuse box or battery of the vehicle (see wiring diagram).
