Fachhändler
Professionelle Montagepartner
Anwendungsbereiche
Produkte
Produktvorteile und Funktionen
schliessen

LOGIN
 

LED-PanelMA-DOWNLOAD

Led Paneljpeg

Please read the instruction manual carefully before usage.

1) Battery or Fuse Box
2) In line fuse
3) Recommended installation position of the On/Off switch

Caution: To avoid electrical shocks and injuries during installation it is essential to disconnect the ground cable (negative pole) from the battery of the vehicle.
1 a) Adhesion: select a suitable location. The surface must be free of dirt and grease. Remove the protective foil of the adhesive pads and apply the panels by pressing firmly.
Please note: Do not attach the adhesive pads to leather, fabric or wood.
1 b) Fastening with screws: Select a suitable position and mark the drill holes. Drill the holes with a 2.0 mm or 2.5 mm drill bit. Unscrew the already pre-mounted screws and replace them with the longer Allen screws
included.
2) Lay the power supply cable (black/black (-), black/white (+)). Important: keep the cable away from heat sources (heater etc.). Note the remaining length of the cable so that the cable is run free of tension. (The cables should be placed so that they cannot fray or break!)
3) Connection (power supply) over fuse box (terminal 15/30) or vehicle battery. We recommend interconnecting a suitable On/Off switch (e.g. FOLIATEC KILLSwitch).
Tip: Connect the lamps via the interior lighting or the door opener.
If you have questions, our Technical-Team will gladly assist you (Tel. +49 (0)911 975 440).

Safety precautions: Reverse battery connection, improper installation, manipulation of components, etc. can constitute a danger and will void any and all warranty claims. Mount at a protected location so that damages through external influence such as foot contact when entering the
vehicle are avoided. Check the panels to assure a secure fit as well as the electrical connections on a regular basis. Take special care that none of the cables are pinched or buckled and are protected from chafing or breakage.

Note: The scope of the Federal Motor Vehicle Safety Standards does not allow installation. For jurisdiction outside of the Federal Republic of Germany: Please take the country specific vehicle registration codes into consideration.

Rated voltage: 12V
Rated current: 35mA, 0,42W
LEDs: 4 pcs., Ø 3mm
Cable lengths: 300cm/118’’