LED-DotSpots

You also need: Metal drill 9mm, possibly round file, rechargeable screw driver, cable lugs, flat nose pliers, crimp connections.
Warning: Before getting starting the installation, disconnect the battery cables to prevent electrical shock and injury. 

1) Select a suitable installation location/ position. Take the installation
depth into consideration.
2) Drill the mounting hole with a 9mm drill bit.
3) Remove the locknut and the washer.
4) Position the DotSpot and check if the diameter of the drilled hole is big
enough. Increase the diameter of the hole with a round file if necessary.
5) Fasten the DotSpot with washer and locknut.
6) Connect the DotSpot according to the wiring diagram.

Safety instructions: Use a suitable safety fuse and have the installation checked by an authorized automotive shop to avoid cable fire, short circuits etc. Mount at a protected location so that damages through external influence such as foot contact when entering the vehicle are avoided. Check the DotSpots to assure a secure fit as well as the electrical connections on a regular basis. Take special care that none of the cables are pinched or buckled and are protected from chafing or breakage. improper installation, manipulation of components, etc. can constitute a danger and will void any and all warranty claims.
Please note: Installation is not permitted under the (German) Road Traffic Law. Please observe the countryspecific legal requirements.
Recommendation: Install the DotSpots only in the interior of the vehicle!

Input voltage: 12V
Rated current: 25mA
Power rating: 0,24W
The LEDs are CE-tested. They have an average lifespan of 10,000 hours.