LED-Control Light

Please read the instruction manual carefully before usage.

1) Fuse box (terminal 30 or 15) or battery
2) Recommended installation of an On / Off switch (e.g. FOLIATEC KILLSwitch without illumination)
3) Control-light
4) User (e.g. LED-light)

Version with chrome rings
Package content: 1 control-light with LED (8 mm Ø), connection cable (14.5 cm).
You also need: Rechargeable drill, drill bit (13 mm), cable ties, clamp type socket / crimp connection.
Caution: Make sure to disconnect the vehicle battery prior to installation!
1) Select a suitable position for the installation of the control-light. Also note the installation depth (26 cm).
2) Drill the installation hole. Make sure not to damage any underlying parts.
3) Push the control-light into the hole from the front and press carefully until the retention hook snaps in place.
4) Connect the cable according to the schematic diagram.

Version with reflector
Package content: 1 control-light with LED (5 mm Ø), connection cable (10 cm).
You also need: Rechargeable drill, drill bit (13 mm), cable ties, clamp type socket / crimp connection.
Caution: Make sure to disconnect the vehicle battery prior to installation!
1) Select a suitable position for the installation of the control-light. Also note the installation depth (18 cm).
2) Drill the installation hole. Make sure not to damage any underlying parts.
3) Remove the nut from the screw thread of the control-light.
4) Push the control-light into the hole from the front. Screw the nut on the control light from the back by hand.
5) Connect the cable according to the schematic diagram.

Caution: The LED-capacitor / resistor is located in the power cable, do not buckle!
Rated voltage: 12V
Rated current: 20mA
Warranty claims for reverse pole connection, improper installation, manipulation of components etc. will not be honored.