Please read the instruction manual carefully before usage.
Thouroughly clean the glass or plastic surface to be covered removing all dust, dirt or oil residue.
1) Cut the HEADLIGHT-Film following your headlights contours and allowing a 1 cm border. Remove the release liner and attach the film to an edge of the headlight. Warm the film and the surface to be covered lightly using the hair drier. Caution: Warming the film too much will destroy it.
2) Apply the warmed film by stretching it and pressing it in place with your thumb. Working in steps apply the film evenly watching out for bubbles.
3) Finally, press the film into the corners and along edges using the squeegee included in the package (not with XENON film).
Special tips for applying XENON film:
A) For strongly bulging headlight glass cut and apply the film in two parts.
B+C) Use only the wet application process with XENON film. Remove the overhanging, excess film with the cutter knife.
D)Tip: The film can be applied in a pattern leaving uncovered spaces.
