Question: [1]
How does the ATOMIZER Kit work?
The kit gets the required pressure from the spare tire to press finely nebulized water from the windshield washer system water tank through the spray nozzles.
The control mode of the ATOMIZER kit works with the provided regulating valve. The activation depends on the size of the tire and the pressure of the tire.
The ATOMIZER kit was tested from us at a 18`` tire (4.0 bar air-pressure) – we were able to get around 5-6 "firings"!
Please check the tire index (max. air pressure filling) of your spare tire.
The Atomizer Kit is not permitted for use in traffic for the following reasons:
- If the jets are mounted incorrectly and spray passers by with water, this is legally considered as bodily harm and can carry the relevant penalty.
- If the kit is used with a CO2 gas canister, as recommended, this is also not permitted, as driving with pressurized containers in passenger vehicles is prohibited (due to the danger of explosion in the event of an accident).
If you decide to follow the instruction manual and use the Profi Tip, please be aware that you require a CO2 canister with a water siphon closure. To convert it you need parts (pressed connecting part = a hose with a pre-mounted screw cap) from a compressed air specialist. These parts differ depending on the water siphon used. An alternative to the water siphon is an electric air compressor (available in electrical specialist warehouses). This compressor should have a capacity of 4-5 bar.
Please be aware of the diameter of the hose, in some cases a reducing piece is necessary.
All datas are without engagement.
Question: [3]
Is it possible to agglutinate the chrome design film three-dimensional?
It is only possible to agglutinate the chrome design films two-dimensional - because of its metalized surface stretching and working with a hot air pistol don`t work.
All datas are without engagement.
