|
|
|
|
|
 |
 |
 |
| |
 |
Application – in half the time
Unpack, apply and enjoy the advantages of your AutoGlass Film!
Contains everything you need for easy wrinkle- and bubble-free DIY application even on curved windows:
IT´S SO EASY!
Before installation of the film clean the window from the inside accurately.
1 ] Remove the clear protective film
2 ] Spray the adhesive layer of the film and the inside of the window with cleaning/application liquid.
3 ] Applying the film and squeezing out the moisture.
TIP:
Read all of the instructions before mounting
Packaging includes cutter, squeegee, installation fluid and installation instructions
Dust particles under the film
Even if the film is applied in a closed room, a small amount of dust particles under the film are virtually unavoidable. This is due to completely normal air pollution.
To minimize the risk, we suggest a draught-free closed room (keep doors and windows closed during application).
Also, there is less dust in the air on days with a higher level of humidity.
...if you’re tired of your film...
AutoGlass Film can be removed easily, without any problems.
Please note that pulling the film off jerkily could damage heating or antenna wires attached to the window.
Warm the film, i.e. with a hairdryer and pull it off slowly and evenly at an acute angle. To remove the remainder of the adhesive we recommend using FOLIATEC ADHESIVE Remover Item No. 2250.
|
|
|
 |
 |
 |
|
|
|
|
|
|
Buying / fitting