Automotive window films
For the FRG (area of the StVZO, the German Road Traffic Licensing Regulations), ECE regulation 43 (ECE appendix 3, paragraph 9.1.4.1) serves as the legal foundation.
(1) Use on rear and rear side windows
FOLIATEC® Automotive Window Film is approved for use on rear side windows and the rear window in connection with a second exterior mirror. There is no legally prescribed minimum light transmission level. The film must not be wedged under the rubber seal around the window frame. The German ABG (general design certification) approval number on the film must be legible in at least one place on each window fitted with the film after installation.
After the film has been installed, an ABG approval certificate is issued. This is to be kept in the vehicle for verification purposes.
RETROACTIVE ENTRY IN THE VEHICLE DOCUMENTS IS NOT NECESSARY!
For regions outside the Federal Republic of Germany: please observe the approval conditions of the respective country.
(2) Use on front side windows and/or windshield
(windows which are important for the driver’s vision)
For the FRG (area of the StVZO, the German Road Traffic Licensing Regulations), ECE regulation 43 (ECE appendix 3, paragraph 9.1.4.1) serves as the legal foundation. Use on front side windows is permitted if an inspection yields a light transmission of no less than 70% (vehicle window incl. window film). An individual inspection for each vehicle is mandatory (technical acceptance in accordance with §21 of the StVZO) – provided that the technically accredited testing laboratory has certified light transmission measuring devices. Remark: up to now no testing laboratory has possessed the corresponding measuring devices capable of measuring vehicle windows in an ‘installed position’ on the vehicle in accordance with ECE regulation 43 with the required measurement accuracy.
Due to the introduction of „FOLIATEC® TLG 43A“ such a measurement is no longer impossible.
NOW THE INSTALLATION OF FOLIATEC® Automotive Window Films ON THE FRONT SIDE WINDOWS CON BE OFFICIALLY ENLISTED IN THE VEHICLE DOCUMENTS!
Please note: The Installation of films on the windshield of your car ist generally forbidden
Luminous transmission
FOLIATEC® TLG 43A is the first mobile luminous transmission tester examined by the German „Materialprüfungsamt“ and certified bei the „Kraftfahrt-Bundesamt“.
All earlier efforts to develop such a device had failed, due to the disability to maintain the legally regulated measuring tolerances during a comparison of different consecutive measurements. The MPA, for the first time, can now acknowledge TLG 43A’s compliance with any tolerance regulations. According to such a positive outcome, the KBA was able to officially certify the TLG 43A for a measurement of luminous transmission concerning the allowance to install Automotive Window Films on front side windows.
Therefore the device can provide the core of SECURLUX® PASSENGER PROTECTION SYSTEM.
SECURLUX PASSENGER PROTECTION SYSTEM
BASIC PROBLEM Unprotected windows in the front of your car bear a whole series of problems for you and your passengers.
FOLIATEC® has developed the solution for securing the front side windows of your car – in accordance with ECE Regulation 43 – in order to provide better protection against UV-rays, break-ins and shattered glass: SECURLUX® PASSENGER PROTECTION SYSTEM:
|
 |  |  |  |
APPLICATION
1. Measurement
Most side windows are already produced with a tinted effect. For securing the legally regulatet minimum luminous transmission of 70% for front side windows as well as advising against an installation of window films in that case, the luminous transmission of your front side windows will be checked with FOLIATEC® TLG 43A before the installation of the SECURLUX® Protective Film.
2. Installation
The suitability of your front side windows for the SECURLUX® Protective Film having been proven, you can choose between a professional installation by an authorised FOLIATEC® STYLINGTEAM Partner or self-installation with one of our do-it-yourself packages.
3. Test
Afterwards an officially certified expert will test the luminous transmission of your front side windows including the SECURLUX® Protective Film via FOLIATEC® TLG 43A.
4. Allowance
An officially certified expert will grant permission by controlling the measurement report and enlisting the test in your vehicle documents, in accordance with the general design certification of SECURLUX® Protective Film.
Our Online Shop
All items can be ordered in our online shop. They are comfortably sent to your home.
